Home/Metal Detectors/Aggregate Industry Detectors

ER TYPE

It is the star product of our range for its simple operation and high performance.
Composed of a single detector plate. It is installed under the conveyor belt, and is ideal to protect secondary or tertiary mills with a granulometry not exceeding 100 mm and a material layer height of approximately 150 mm.

Download datasheet

ERS TYPE

Metal detector composed of a coil that is installed under the conveyor belt. Governed by microprocessor, its sensitivity is higher than that of the ER model, its detection height is maximum 200 mm.
Disposes of the ATEX CERTIFICATION AREA 22.

Download datasheet

GR TYPE

It consists of two coils, one transmitter and another signal receiver. The coils are installed in the belt form ing a tunnel through which the material passes to be analysed. Its i nstallation is very simple because the band has not be cut.

Download datasheet

GRS TYPE

Metal detector composed of two detector coils, being a removable system for insertion in the conveyor belt. Governed by microprocessor, its sensitivity and stability are very high.
Disposes of the ATEX CERTIFICATION AREA 22 AND AREA 21.

Download datasheet

CONTROL BOX

Common to all metal detectors in our range. The sensing coils are connected through an appropriate electrical conduction to the control box. From this box, electrical conduits go to the circuits that must be separated (two independent circuits) as well as to an acoustic alarm that signals the performance of the detector.

EXAMPLES OF PROTECTION FOR CRUSHING MACHINERY

Typical application examples A B C
Material to be ground Árido Árido Árido
Granulometry in mm. 0/60 0/120 0/200
Belt width in mm. 800 800 800
Belt speed in m/sec 1 1 1
Material layer height in mm. Árido Árido Árido
Recommended detector model ER GR GR